QB Series Peripheral Pump
Operating Conditions
Suction lift up to 8 m.
Liquid temperature up to +40℃.
Ambient temperature up to +40℃.
Max. Working pressure: 6 bar.
Motor
2 pole induction motor.
Single-phase, 50Hz / 60Hz.
Insulation: Class B.
Protection IP 44.
With capacitor and thermal overload protection.
Material
Pump body: Cast iron.
Motor support: Aluminum / Cast iron.
Impeller: Brass.
Motor shaft: Stainless steel or CS45#.
Mechanical seal: Ceramic-Graphite.
Copper Winding.
Pump Common Failures and Maintenance
| Problem | Reason Analyze | Maintenace |
| Pump fails to run | 1、thermal fuse burned
2、pump jammed or rusted 3、capacitor damaged 4、Low voltage 5、pump is working in interruption (Thermal protector working） 6、pump burned |
1、Change the thermal fuse
2、clear the eyewinker and rust 3、change capacitor 4、Use voltage stabilizer,enlarge cable wire diameter and shorten the cable length to decrease cable pressure and loss 5、Check whether pump voltage too high or too low or pump overloaded working。Find the problem then solve 6、Repair the pump |
| Pump cannot pump out water | 1、No enough water in the water filling hole
2、too high suction 3、water absorption tube connection leak gas 4、Lack water source，bottom valve on the water 5、Mechnical seal leak water 6、Pump head、pump body broken |
1、Add full water in the water filling hole
2、remove pump to reduce the pump suction 3、use teflon tape or sealant to tighten the inlet connection again 4、make the bottom valve surbmerse in the water 5、change or repair the mechanical seal 6、change pump head or pump body |
| Small flow,low lift | 1、impeller and pump head wear
2、Mechnical seal leak water 3、Impeller blocked by sundries 4、filter blocked 5、Low voltage |
1、change the impeller ,pump head
2、change or repair the mechanical seal 3、clear the impeller sundries 4、clear the sundries on the filter 5、Enlarge voltage |
Our service:
Marketing Service
100% tested CE certified blowers.Special customized blowers(ATEX blower,belt-driven blower) for special industry.Like gas transportation,Medical industry…Professional advice for model selection and further market development.Pre-sales service:
•We are a sales team, with all technical support from engineer team.
•We value every inquiry sent to us, ensure quick competitive offer within 24 hours.
•We cooperate with customer to design and develop the new products. Provide all necessary document.After-sales service:
•We respect your feed back after receive the motors.
•We provide 1years warranty after receipt of motors..
•We promise all spare parts available in lifetime use.
•We loge your complain within 24 hours.
